TM 9-2815-237-34
2-41. ENGINE ASSEMBLY FROM SUBASSEMBLIES (Cent’d)
g. Timing Gear Cover
1.
2.
3.
4.
5.
Install front cover seal (19) in timing gear cover (15), ensuring lip of seal (19) faces inward.
Apply a 3/32 in. (2 mm) bead of sealer to sealing surface on timing gear cover (15), following diagram
shown.
Install timing gear cover (15) on cylinder block (16) with four washers (17), capscrews (18), and short
capscrews (20). Tighten four capscrews (18) and short capscrews (20) to 33 lb-ft (45 N•m).
CAUTION
Maintain 0.040 in. (1.02 mm) minimum clearance between baffle
plate and pump drive gear to avoid noise.
Install baffle plate (14) in timing gear cover (15) with two capscrews (12) and nut (13). Tighten
capscrews (12) and nut (13) to 33 lb-ft (45 N•m).
NOTE
Perform step 5 for 6.5L engines.
Install rpm sensor (22) in timing gear cover (15) with capscrew (21).
2-165
|
|
