TM 9-2815-237-34 2-14          Change 1 2-15.   ENGINE DISASSEMBLY INTO SUBASSEMBLIES (Cont’d) e.  Intake Manifold 1. Remove fuel filter line clamp (1) from stud (2). NOTE •  Note location of studs for installation. •  Perform step 2 for 6.2L engines. Perform step 3 for 6.5L engines. 2. Remove six intake manifold capscrews (5), ten studs (2), and sixteen washers (3). 3. Remove four intake manifold capscrews (5), twelve studs (2), and sixteen washers (3). 4. Remove four injection line clips (4). 5. Remove intake manifold (6) and two gaskets (7) from cylinder heads (8). Discard gaskets (7). NOTE •  Perform steps 6 through 8 for turbo engines. •  Outer intake manifold is removed before engine is removed from vehicle. 6. Remove eight intake manifold studs (8.1) from intake manifold (8.2). .WARNING. Gaskets installed on some 6.2L engines assembled prior to 1991 may contain asbestos.  Gaskets should be removed with a scraper or putty knife and then be disposed of IAW current directives. Inhalation of asbestos fibers can cause respiratory ailments. 7. Remove intake manifold (8.2) and gasket (8.3) from cylinder head (8.4).  Discard gasket (8.3). 8. Repeat steps 6 and 7 for opposite side.