TM 9-2815-237-34 2-27. OIL PUMP REPAIR (Cont’d) 6. 7. 8. 9. 10. 11. 12. 13. Inspect  oil  screen  (7)  for  damage  or  blockage.  If  blocked  or  damaged,  perform  steps  8  through  12; if not, go to next step. Inspect  pickup  tube  bracket  (9)  for  damage.  If  damaged,  perform  steps  8  and  12;  if  not,  go  to  step Remove  capscrew  (8)  and  pickup  tube  bracket  (9)  from  oil  screen  (7). Place  pump  cover  (5)  in  soft-jawed  vise. Using  soft-head  hammer,  remove  oil  screen  (7)  from  pump  cover  (5). Using soft-head hammer, install oil screen (7) in pump cover (5) until bead (6) seats on pump cover  (5). Install pickup tube bracket (9) on oil screen (7) and install capscrew (8). Finger tighten capscrew  (8). Inspect  regulator  valve  plug  (10)  for  damage.  Replace  if  damaged. 13. d.  Assembly NOTE For  general  assembly  instructions,  refer  to  para.  2-12. 1. Install regulator valve (2) and regulator spring (1) in pump cover (5) with retaining pin (4). 2. Install drive gear (15) and idler gear (11) into pump body (14) and aline reference marks. 3,  Apply  small  amount  of  OE/HDO  into  pump  body  (14). 4. Install pump cover (5) on pump body (14) with four capscrews (3). Tighten capscrews (3) to 120 lb-in. (14  N•m). 5. Install coupling (12) and shaft extension (13) on end of drive gear (15). 2-80