TM 9--2815--247--34 0030 00--1 EXHAUST MANIFOLDS AND ASSOCIATED PARTS (R.B.) REPLACEMENT 0030 00 THIS WORK PACKAGE COVERS: Removal, Inspection, Installation INITIAL SETUP: Tools and Special Tools General mechanic’s tool kit (item 19, WP 0103 00) Torque wrench (item 50, WP 0103 00) Crowfoot attachment (item 92, WP 0103 00) Materials/Parts Gaskets (7) (item 19, WP 0102 00) Self--locking nuts (30) (item 56, WP 0102 00) Lockwashers (2) (item 147, WP 0102 00) Self--locking nuts (2) (item 53, WP 0102 00) Pipe plugs (6) (item 106, WP 0102 00) Anti--seize compound (item 1, WP 0100 00) Self--locking nuts (2) (item 55, WP 0102 00) Lubricant (item 12, WP 0100 00) Equipment Conditions Engine level on flat surface (WP 0021 00) Engine cleaned and drained (TM 9--2350--292--20) Equipment Conditions -- Continued Fans, covers, and top deck removed (TM 9--2350--292--20) Fuel injector tubes, brackets and associated parts (R.B.) removed (WP 0037 00) Turbocharger assembly (R.B.) removed (WP 0041 00) Manifold heater fuel return lines removed (TM 9--2350--292--20) Smoke generating fuel lines removed (TM 9--2350--292--20) Oil breather tube removed (TM 9--2350--292--20) Right rear shrouds removed (WP 0053 00) References TM 9--2350--292--20 Removal NOTE Perform Removal steps 1 through 7 and Installation steps 7 through 11 for maintenance of exhaust manifold con- nected to cylinders 1R, 2R, and 3R. Perform Removal steps 1 through 13 and Installation steps 1 through 11 for maintenance of exhaust manifold connected to cylinders 4R, 5R, and 6R. 1.  Remove two self--locking nuts (1) and two screws (2) from two retaining straps (3) and two retaining straps (4). Discard self--locking nuts. Figure 26 2 3 4 1 FLYWHEEL END