TM 9--2815--247--34 0054 00--8 FAN DRIVE CLUTCH ASSEMBLY AND ASSOCIATED PARTS REPAIR -- CONTINUED 0054 00 Inspection -- Continued 8.   Inspect two clutch disks (27) and two clutch disks (28) for excessive heat distortion, cracks, warpage, or other abrasive damage. Replace clutch disks if defects are found. 9.   Measure thickness (38) of two clutch disks (28). Replace clutch disks if not within the following limits. REF NO POINT MEASUREMENT SIZES AND FITS OF NEW PART inches (mm) WEAR LIMITS 38 Thickness of clutch disk 0.1900 (4.8260) 0.1860 (4.7244) 0.1840 (4.6736) Figure 55 38 27 28 10. Measure inside diameter (39) of access cover (13). Replace access cover if not within the following limits. 11. Measure outside diameter (40) of flange (23). Replace flange if not within the following limits. REF NO POINT MEASUREMENT SIZES AND FITS OF NEW PART inches (mm) WEAR LIMITS 39 Inside diameter of bearing bore in access cover 3.1496 (79.9998) 3.1503 (80.0176) 3.1506 (80.0252) 40 Outside diameter of bearing surface on flange 1.3781 (35.0037) 1.3785 (35.0139) 1.3779 (34.9986) Figure 55 39 13 23 40