TM 9--2815--247--34 0058 00--1 FRONT ENGINE LIFTING EYES, GUIDES, AND TIME TOTALIZING METER REPLACEMENT 0058 00 THIS WORK PACKAGE COVERS: Removal, Installation INITIAL SETUP: Tools and Special Tools General mechanic’s tool kit (item 19, WP 0103 00) Materials/Parts Gasket (item 20, WP 0102 00) Self--locking nuts (8)(item 55, WP 0102 00) Self--locking nuts (2) (item 47, WP 0102 00) Lubricant (item 12, WP 0100 00) Equipment Conditions Engine level on flat surface (WP 0021 00) Fuel/water separator removed for maintenance of left lifting eye or left guide (TM 9--2350--292--20) Equipment Conditions -- Continued Throttle control solenoid removed for maintenance of right lifting eye or right guide (WP 0048 00) Fuel hose clamp removed from left lifting eye (TM 9--2350--292--20) Wiring harness 3W202 clamps removed from left lifting eye (TM 9--2350--292--20) Manifold pump assembly bracket removed for maintenance of right engine guide (TM 9--2350--292--20) Removal 1.   Remove eight self--locking nuts (1) and two self--locking nuts (2). Discard self--locking nuts. 2.   Slide two engine installation guides (3 and 4) off of studs (5). 3.   On the right side, slide time totalizing meter (6) off of studs and remove engine lifting eye (7). 4.   On the left side, remove engine lifting eye (8) and gasket (9). Discard gasket. 5.   Inspect parts for damage and replace as required. Figure 1 1 1 1 1 3 2 5 5 4 6 7 5 5 9 8