TM 9--2815--247--34 0059 00--1 CYLINDER HEAD ASSEMBLY REPLACEMENT 0059 00 THIS WORK PACKAGE COVERS: Removal, Installation INITIAL SETUP: Tools and Special Tools General mechanic’s tool kit (item 19, WP 0103 00) Torque wrench (item 51, WP 0103 00) Torque wrench adapter (item 60, WP 0103 00) Torque wrench adapter (item 61, WP 0103 00) Torque wrench adapter (item 62, WP 0103 00) Torque wrench adapter (item 63, WP 0103 00) Crankcase protectors (item 58, WP 0103 00) Piston ring compressor (item 40, WP 0103 00) Chain lift assembly (item 72, WP 0103 00) Engine turning tool (item 1, WP 0104 00) Snapring pliers (item 44, WP 0103 00) Hammer hand (item 102, WP 0103 00) Materials/Parts Packing, preformed (item 87, WP 0102 00) Retaining rings (2)(item 118, WP 0102 00) Lubricant (item 12, WP 0100 00) Antiseize compound (item 1, WP 0100 00) Sealant (item 2, WP 0100 00) Safety goggles (item 28, WP 0100 00) Equipment Conditions Engine on maintenance stand (WP 0056 00) Camshaft assembly removed For left bank (WP 0073 00) For right bank (WP 0077 00) Exhaust manifolds removed For left bank (WP 0029 00) For right bank (WP 0030 00) Aftercooler assemblies removed (WP 0033 00) Cylinder deflectors and shrouds removed (WP 0052 00) Personnel Required Two NOTE Single or multiple cylinder head assemblies can be re- moved from each bank. If cylinder head assemblies only need to be removed from one bank, major assemblies can be removed from just one bank. Removal 1.   Rotate maintenance stand so cylinder head assembly (1) is horizontal. Figure 5 1