TM 9--2815--247--34
0071 00--4
LUBRICATING NOZZLE ASSEMBLY REPAIR -- CONTINUED
0071 00
Adjust
1. Plug off all nozzles (6) where cylinders are removed except one, with hose (8) and hose clamps (9).
Figure 8
6
9
8
2. Remove pipe plug (10) and install improvised tool (11) to block off oil passage to the fan towers.
3. Remove pipe plug (12) and connect a 60 psi (413.7 kpa) oil supply to this passage.
NOTE
Oil supply should be at least three gallons of SAE--10 oil
with pump or pressurized container and a pressure
gauge.
4. Install target fixture (13) on cylinder pins (14) and secure with knob (15).
5. Operate oil supply at 60 psi (413.7 kpa) and, using bending tool (16), adjust nozzle (6) to provide accurate oil
stream to center of target (17).
Figure 74
11
13
17
14
15
16
16
6
10
12
|
|
