TM 9--2815--247--34 0076 00--1 CAMSHAFT, DRIVE GEARS, AND ASSOCIATED PARTS REPAIR 0076 00 THIS WORK PACKAGE COVERS: Removal, Disassembly, Inspection, Assembly, Installation INITIAL SETUP: Tools and Special Tools General mechanic’s tool kit (item 19, WP 0103 00) Mechanical puller (item 31, WP 0103 00) Outside micrometer caliper set (item 9, WP 0103 00) Telescoping gauge set (item 16, WP 0103 00) Thickness gauge blade (item 3, WP 0103 00) Thickness gauge blade (item 4, WP 0103 00) Thickness gauge blade (item 5, WP 0103 00) Torque wrench (item 51, WP 0103 00) Engine turning tool (damper end) (item 2, WP 0104 00) Snap ring pliers (item 44, WP 0103 00) Torque wrench (item 50, WP 0103 00) Materials/Parts Gasket (item 7, WP 0102 00) Gasket (item 8, WP 0102 00) Preformed packing (item 88, WP 0102 00) Preformed packing (item 76, WP 0102 00) Preformed packing (item 83, WP 0102 00) Lockwashers (2) (item 149, WP 0102 00) Lockwashers (2) (item 147, WP 0102 00) Materials/Parts -- Continued Air duct hose (item 37, WP 0102 00) Self--locking nuts (4) (item 55, WP 0102 00) Inter cylinder sleeve (5) (item 138, WP 0102 00) Retaining ring (item 113, WP 0102 00) Prussian blue (item 17, WP 0100 00) Lubricant (item 12, WP 0100 00) Equipment Conditions Rocker arm covers removed (WP 0026 00) Pump drive adapter assembly removed to repair right side camshaft (WP 0078 00) Fuel/water separator filter bracket removed to repair left side camshaft (WP 0090 00) Shrouds removed (TM 9--2350--292--20 and WP 0053 00) References TM 9--2350--292--20 NOTE Left and right bank camshaft, drive gears and associated parts are replaced the same way. This task replaces only one. The differences will be noted in this task. Cylinders are equipped with replaceable camshaft bear- ings. The bearing half in the cover should remain with the cover.