TM 9--2815--247--34 0076 00--11 CAMSHAFT, DRIVE GEARS, AND ASSOCIATED PARTS REPAIR -- CONTINUED 0076 00 Installation -- Continued CAUTION If marked tooth is not visible, rotate flywheel counter- clockwise 360 degrees, as viewed from the rear, until “1R INJ PORT CLOSE” aligns with timing mark and marked tooth is visible in timing hole on injection pump. 9.   Rotate flywheel (47) counterclockwise, as viewed from the rear, approximately 140 degrees until “6L INT CLOSE 0.100 CLR” or “6R INT CLOSE 0.100 CLR” timing mark (51) aligns with engine timing mark (49), then rotate fly- wheel an additional 360 degrees until “6L INT CLOSE 0.100 CLR” timing mark (51) aligns with engine timing mark (49) the second time. 6R INT CLOSE 0.100 IN. CLR 6L INT CLOSE 0.100 IN. CLR CENTERLINE 0F CRANKSHAFT 1R INJ PORT CLOSE 22.5 DEG. TIMING POINTER 47 49 51