TM 9--2815--247--34 0085 00--8 ACCESSORY DRIVE HOUSING ASSEMBLY AND ASSOCIATED PARTS REPAIR -- CONTINUED 0085 00 Inspection -- Continued 6.   Measure inside diameter (41) of small through bore in housing (8). Replace housing if not within the following lim- its. 7.   Measure inside diameter (42) of small lower bore in housing (8). Replace housing if not within the following limits. 8.   Measure inside diameter (43) of large lower bearing bore in housing (8). Replace housing if not within the follow- ing limits. 9.   Measure inside diameter (44) of oil seal bore in housing (8). Replace housing if not within the following limits. REF NO. POINT OF MEASUREMENT SIZES AND FITS OF NEW PARTS inches (mm) WEAR LIMITS 41 Inside diameter of small through bore in housing 1.1440 (29.0576) 1.1460 (29.1084) 1.1470 (29.1338) 42 Inside diameter of small lower bore in housing 3.0625 (77.7875) 3.0635 (77.8129) 3.0638 (77.8205) 43 Inside diameter of large lower bearing bore 3.4368 (87.2947) 3.4375 (87.3125) 3.4378 (87.3201) 44 Inside diameter of oil seal bore in housing 44.3255 (1.7510) 44.3255 (1.7510) 44.3255 (1.7510) Figure 30 8 43 41 42 44