TM 9--2815--247--34 0088 00--11 AUTOMATIC FUEL INJECTION ADVANCE CONTROL ASSEMBLY AND ASSOCIATED PARTS REPAIR -- CONTINUED 0088 00 Inspection -- Continued 14. Measure width (56) of vane (34). Replace vane if not within the following limits. 15. Measure inside diameter (57) of vane (34). Replace vane if not within the following limits. 16. Measure width of slots (58) in vane (34). Replace vane if not within the following limits. 17. Measure inside diameter (59) of cover (20). Replace cover if not within the following limits. 18. Measure outside diameter (60) of cover (20). Replace cover if not within the following limits. REF NO. POINT OF MEASUREMENT SIZES AND FITS OF NEW PART inches (mm) WEAR LIMITS 56 Width of vane Check concurrently with vane housing to provide 0.0010--0.0015 (.0254--.0381mm) end clearance at assembly 2.1214 (53.8836) 57 Inside diameter of vane 1.8730 (47.5742) 1.8735 (47.5869) 1.8740 (47.5996) 58 Width of slots in vane 0.1020 (2.5908) 0.1060 (2.6924) 0.1070 (2.7178) 59 Inside diameter of cover 1.8125 (46.0375) 1.8130 (46.0502) 1.8135 (46.0629) 60 Outside diameter of cover 2.3735 (60.2869) 2.3745 (60.3123) 2.3730 (60.2742) 20 59 60 57 34 56 58 Figure 33