TM 9--2815--247--34
0095 00--7
REAR FAN DRIVE AND ASSOCIATED PARTS REPAIR -- CONTINUED
0095 00
Assembly
1. Position original shims (14) on end of inner bearing race (side opposite bearing trade mark) of ball bearing (10).
2. Measure the total thickness (32) of bearing race and shims, from shim on inner race to upper face of outer race,
with end play removed. Thickness must be from 0.7891 inch (20.0431 mm) minimum to 0.7911 inch (20.0939
mm) maximum.
3. When total thickness is greater than 0.7911 inch (20.0939 mm) strip 0.002 inch (.0508 mm) thick laminations from
shim pack until correct thickness is obtained.
4. When total thickness is less than 0.7891 inch (20.0431 mm), add 0.002 inch (.0508 mm) thick shims (stripped
from a new shim pack) as necessary.
0.7911 INCHES (20.0939 MM) MAX.
Figure 30
32
REAR FAN
DRIVEN
GEARSHAFT
REAR FAN
DRIVE
BEVEL
GEARSHAFT
10
14
0.7891 INCHES (20.0431 MM) MIN.
BEARING
TRADEMARK
|
|
