TM 9-2815-250-24&P 3-16.   GOVERNOR CONTROL ASSEMBLY REPAIR. This Task Covers: a. Removal b. Installation Initial Setup: Tools/Test Equipment:    Seal (Item 13, Appendix F)    General mechanic's tool kit, automotive    Spring tension washer (Item 30, Appendix F) (Item 15, Appendix G)    Wire mesh (Item 14, Appendix F)    Snapring pliers (Item 26, Appendix G) Equipment Conditions: Materials/Parts:    Injection pump removed (para 3-15).    Lockwasher (Item 26, Appendix F)    O-ring (Item 37, Appendix F) a. REMOVAL 1. Remove  screw  (1),  spring  tension  washer  (2),  two  levers  (3  and  5),  and  bushing  (4)  from  mounting  plate  (7). Discard spring tension washer. 2. Remove stop lever (8) and spring (6) from mounting plate (7). 3. Remove O-ring (9) from stop lever (8).  Discard O-ring. 4. Remove  screw  (10),  lockwasher  (11),  washer  (12),  lever  (13),  and  spring  (21)  from  speed   control   lever   (18). Discard lockwasher. 5. Remove seal (14) and wire mesh (15) from speed control lever (18).  Discard seal and wire mesh. 6. Remove screw (20) and speed control lever (18) from crankcase (19). 7. Remove two nuts (17) and screws (16) from speed control lever (18). 3-54