ARMY TM 9-2815-253-24 AIR FORCE TO 38G1-93-2 MARINE CORPS TM 2815-24/3 FIGURE 3-20.  Governor Weights 3-23.3.  Inspection. a. Inspect all external components for corrosion. b. Inspect all threaded components for thread damage and rounded corners on hex heads. c. Inspect all springs for broken coils, distortion, or missing ends. d. Inspect area components for enlarged or worn holes. e. Inspect area bushings for scores or other damage. 3-23.4.  Installation. a. Carefully install governor lever (6, FIGURE 3-19) assembly onto camshaft and use care to ensure that flywheel end of fuel pump rack is located in its housing. b. If removed, install pivot retainers (7 and 10) on upper and lower pivot pins (4 and 8). c. Secure governor lever (6) to lower pivot support (5) using pivot pin (4).  Connect spring (3) to pivot pin (4). d. Install top pivot pin (8) through upper pivot support (9) and into governor lever (6).  Be sure to use original end play shims (11). NOTE Long loop of speeder spring (1) connects to retainer (2). e. Connect speeder spring (1) to retainer (2) and lever (29). f. Check governor end play.  Refer to paragraph 3-23.5. g. Install gear end cover.  Refer to paragraph 3-28.3. h. Install fuel injection pumps.  Refer to paragraph 3-13.4. i. Perform governor system adjustments.  Refer to paragraph 3-23.5, steps b thru d. 3-39