ARMY TM 9-2815-254-24 AIR FORCE TO 38G1-94-1 j. k. I. m. n. o. p. q. Align  idler  gear  setting  mark  X  with  crankshaft  timing  gear  setting  mark  X-X”. Align idler gear setting mark “Y” with camshaft timing gear setting mark “Y-Y”. Install thrust collar (2) on idler gear and shaft and secure with two screws (1). Tighten screws to 168 in-lbs (19.0  Nm). Install cylinder head, refer to paragraph 3-27.6. Install fuel injector pump, refer to paragraph 3-11.6. Install front gear cover, refer to paragraph 3-25.3. Install oil pan, refer to paragraph 3-17.3. InstaII PCV system, refer to paragraph 3-20.3. r. Install water pump, refer to paragraph 3-7.4. s. Install thermostat housing, refer to paragraph 3-6.4. t. Install alternator, refer to paragraph 3-24.5. u. Install flywheel housing, refer to paragraph 3-31.3. v. Install starter, refer to paragraph 3-23.6. w. Install fuel filter, refer to paragraph 3-9.4. x. Install oil filter, refer to paragraph 3-14.3. 3-31.  FLYWHELL  AND  HOUSING. 3-31.1.  Removal. a. Remove starter, refer to paragraph 3-23.1. b. Block flywheel (3, FIGURE 3-107) with a piece of hard wood. c. Remove  four  bolts  (1)  and  washers  (2)  securing  flywheel  assembly  (3)  to  basic  flywheel  (6).  Remove  flywheel assembly (3) d. Loosen six flywheel attaching bolts (4) a little at a time and in sequence shown in FlGURE 3-108. 3-158