ARMY TM 9-2815-255-24
AIR FORCE TO 38G1-95-2
MARINE CORPS TM 2815-24/4
q.
Disassemble transfer pump regulator components as follows:
(1)
Remove end plate adjusting plug (7, FIGURE 3-52). Shake regulator (8) to remove piston (9) and spring
(10).
(2)
Using O-ring pick, remove piston seal (11) from regulator (8).
(3)
If damaged, remove roll pin (12) from regulator (8), refer to FIGURE 3-53.
FIGURE 3-53. Transfer Pump Regulator Components
r. Remove four blades (13, FIGURE 3-52), two springs (14), and liner (15), refer to FIGURE 3-54.
FIGURE 3-54. Removing Transfer Pump Blades (Typical)
s.
Using a piece of wire with a hook, remove preformed packing (16, FIGURE 3-52) from groove in hydraulic head,
refer to FIGURE 3-55.
3-89
|
|
