ARMY TM 9-2815-255-24
AIR FORCE TO 38G1-95-2
MARINE CORPS TM 2815-24/4
3-37.3. Installation.
CAUTION
Flywheel housing gasket must contain a silicone bead. If no bead is present, apply a thin bead
of sealing compound (LOCTITE 77BR) to gasket to prevent oil leakage.
a.
Install new silicone bead/gasket (9, FIGURE 3-105) on block. Gasket should be a silicone bead.
NOTE
Dip threads of capscrews (6 and 7) in clean engine lubricating oil (MIL-L-2104).
b.
Position flywheel housing (8) on engine block.
c.
Install eight 3/8-inch capscrews (6) and four 5/8-inch capscrews (7). Torque 3/8-inch capscrews (6) to 22 ft-lbs
(30 Nm) initially and retorque to 35 ft-lbs (47 Nm). Torque 5/8-inch capscrews (7) to 170 ft-lbs (230 Nm).
d.
Install crankshaft rear oil seal/wear sleeve (5), refer to paragraph 3-36.2.
e.
Install flywheel, refer to paragraph 3-35.3.
f.
Service engine lubrication system, refer to end item maintenance manual.
Change 3 3-153
|
|
