ARMY TM 9-2815-255-24 AIR FORCE TO 38G1-95-2 MARINE CORPS TM 2815-24/4 d. If  sleeve  bearings  (4  and  12)  were  removed,  use  an  arbor  press,  driver  (JD-252),  and  handle  (10914188)  to install sleeve bearing (4) in idler gear (3) and sleeve bearing (12) in idler gear (11). e. Install lower idler gear (11), thrust washer (10), and nut (8). f. Time camshaft and install upper idler gear (3), thrust washer (2), and capscrew (1), refer to paragraph 3-40.3. g. Install dirt deflector (10, FIGURE 3-118),  new preformed packing (9),  and crankshaft sleeve bearing (8). h. Install oil pan, refer to paragraph 3-20.3. i. Install timing gear cover, refer to paragraph 3-39.3. 3-43.  FRONT PLATE. 3-43.1.  Removal. a. Remove timing gear cover, refer to paragraph 3-39.1. b. Remove camshaft, refer to paragraph 3-40.1. c. Remove fuel injection pump and drive gear, refer to paragraph 3-27.1. d. Remove oil pump and drive gear, refer to paragraph 3-21.1. e. Remove idler gears, refer to paragraph 3-42.1. f. Remove balancer shaft, refer to paragraph 3-41.1. g. Remove five screws (1, FIGURE 3-117) and lockwashers (2) securing front plate (3); remove front plate (3) and gasket (4).  Discard gasket (4) and lockwashers (2). h. Remove oil bypass valve (6) and spring (5). i. If new front plate (3) is to be installed, remove setscrew plugs (7).  Discard plugs. 3-43.2.  Inspection. WARNING Cleaning solvent is flammable and toxic to eyes, skin, and respiratory tract.  Skin/eye protection required.  Avoid repeated/prolonged contact.  Good general ventilation is normally adequate. Change 3   3-170