ARMY TM 9-2815-255-24
AIR FORCE TO 38G1-95-2
MARINE CORPS TM 2815-24/4
Section VI. INTAKE AND EXHAUST SYSTEM MAINTENANCE
3-13. TURBOCHARGER.
3-13.1. Removal.
Warning
After operating engine, allow exhaust system to cool before removal. Failure to observe this
warning could result in personal Injury.
CAUTION
When cleaning turbocharger, do not spray directly into compressor cover or turbine housing. If
turbocharger Inspection is required, do not clean exterior prior to removal. Doing so may wash
away evidence of a potential failure mode.
a.
Thoroughly clean exterior of turbocharger and surrounding area to prevent entry of dirt into air intake system
during removal.
b.
Remove air intake line and exhaust line from turbocharger (11, FIGURE 3-24), refer to end item maintenance
manual.
c.
Loosen clamps securing air intake manifold hose to turbocharger, refer to paragraph 3-15.
d.
Disconnect oil inlet line (1) from fitting (2) on top of turbocharger (11).
NOTE
If it is necessary to remove oil lines, drain lubrication system, refer to end item maintenance
manual.
3-43
|
|
