ARMY TM 9-2815-255-24
AIR FORCE TO 38G1-95-2
MARINE CORPS TM 2815-24/4
3-20.2. Inspection.
a.
Inspect oil pan for cracks, dents, or other damage and replace as necessary.
b.
Inspect plug holes for damage threads and signs of leakage.
3-20.3. Installation.
a.
Put a bead of sealing compound (FORMAGASKET2) on oil pan rail where flywheel housing, front plate, and
timing gear cover attach to cylinder block.
b.
Place a new gasket (5, FIGURE 3-34) and oil pan (4) on engine block and secure with eight bolts (1), twenty bolts
(2), and twenty-eight new lockwashers (3). Install the eight longer bolts (1) in locations noted during removal.
CAUTION
Do not overtighten oil pan-to-timing gear cover capscrews.
c.
Tighten oil pan-to-timing gear cover capscrews to 27 ft-lbs (37 Nm). Tighten all others to 35 ft-lbs (47 Nm).
d.
Service lubrication system, refer to end item maintenance manual.
3-21. OIL PUMP ASSEMBLY.
3-21.1. Removal.
a.
Remove oil pan, refer to paragraph 3-20.1.
b.
Remove nut (1, FIGURE 3-35) and pull gear (2) using a suitable puller. If a suitable puller is not available,
loosen nut (1) several turns and apply force between front plate and gear (2) on two sides of gear with a small pry
bar. Strike nut end of shaft while applying force to gear until gear is free of tapered shaft. Remove nut (1) and
gear (2).
3-65
|
|
