ARMY TM 9-2815-256-24
AIR FORCE TO 38G1-96-2
MARINE CORPS TM 2815-24/5
FIGURE 3-82. Removing Governor Arm
as.
If damaged, disconnect spring (47) from governor arm (44) and linkage hook assembly (46).
at.
If damaged, disassemble linkage hook assembly, by removing screw (79) and washer (80) to separate linkage
assembly (81) from linkage hook (46).
au.
Remove drive shaft (42, FIGURE 3-73) from housing as follows:
(1)
Remove nut, washer, and key (43).
(2)
Remove retaining ring (38), spring washer (39), and thrust washer (40).
(3)
Pull drive shaft (42) from housing.
(4)
Remove two seals (44 and 45) from drive shaft (42).
(5)
Wrap drive shaft (42) in clean rag.
av.
If required, press drive shaft bushing (46) out of housing.
aw.
If required, press two throttle bushings (82 and 83, FIGURE 3-64) out of housing.
ax.
Lift wearing ring (22, FIGURE 3-73) from rotor retainers (23).
ay.
Remove two rotor retainers (23), refer to FIGURE 3-83.
FIGURE 3-83. Removing Rotor Retainers
az.
Remove hydraulic head (17, FIGURE 3-73) off rotor (48).
3-100
|
|
