|
ARMY TM 9-2815-256-24
AIR FORCE TO 38G1-96-2
MARINE CORPS TM 2815-24/5
Section X. FLYWHEEL AND HOUSING ASSEMBLY MAINTENANCE
3-35. FLYWHEEI.
3-35.1. Removal.
a.
Remove starter, refer to paragraph 3-12.2.
WARNING
Flywheel is heavy. Provide adequate lifting device to support weight.
Failure to follow this procedure could result in personal injury.
b.
Remove two capscrews (1, FIGURE 3-125) and washers (2). Replace these with two guide studs.
c.
Remove other two capscrews (1) and washers (2). Install these two capscrews in threaded holes of flywheel (3).
d.
Use two capscrews in step b to jack flywheel (3). off crankshaft.
e.
Remove flywheel (3) and two capscrews (1).
3-35.2. Repair.
a.
If ring gear (4, FIGURE 3-125) is damaged, place the flywheel (3) on a solid flat surface.
b.
Drive ring gear (4) off with a brass drift and hammer.
3-159
|
|
