ARMY TM 9-2815-256-24
AIR FORCE TO 38G1-96-2
MARINE CORPS TM 2815-24/5
c.
Position alternator adjusting strap (3) and secure with capscrew (1), washer (6), and new lockwasher (2). Tighten
capscrew to 35 ft-lbs (47 Nm).
d.
Install fan and spacer, refer to end item maintenance manual.
e.
Install fan drive belts, refer to end item maintenance manual.
f.
Install by-pass hose on water pump and secure with a hose clamp.
g.
Install two oil cooler hoses (2, FIGURE 3-3) and secure to water pump and engine oil cooler with four hose
clamps (1). Install clamp (5) with screw (3) and washer (4).
h.
Install inlet hose on pump inlet and secure with a hose clamp.
NOTE
Air must be expelled from system when system is refilled. Loosen temperature sending unit fitting
at rear of cylinder head or plug in thermostat housing to allow air to escape when filling system.
Retighten fitting or plug when all the air has been expelled.
i.
Service coolant system, refer to end item maintenance manual.
Change 3
3-26
|
|
