ARMY TM 9-2815-256-24
AIR FORCE TO 38G1-96-2
MARINE CORPS TM 2815-24/5
FIGURE 3-51. Dipstick
3-19.2. Installation.
a.
Install jam nut (4, FIGURE 3-51) on tube (3) exposing number of threads above nut as noted during removal.
b.
Screw tube (3) into engine block and tighten jam nut (4).
c.
If in doubt of level accuracy, perform following:
NOTE
Engine should be cold and new filter installed before filling.
(1)
Run engine to circulate oil, drain and fill engine with proper amount of new engine oil, refer to end item
maintenance manual.
(2)
Loosen jam nut (4) and adjust tube until dipstick shows oil level at full mark. Tighten jam nut (4).
d.
Install new preformed packing (2) and dipstick (1).
3-68
|
|
