ARMY TM 9-2815-257-24 AIR FORCE TO 38G1-128-2 MARINE CORPS TM 10155A/2815-24/3 5-32 5-13.  GOVERNOR MAINTENANCE This task covers removal, cleaning, inspection, and installation. INITIAL SETUP Tools: Equipment Condition: Tool Kit, Master Mechanic (Item 3, App. B, Sect. III)     Governor control removed (Para. 4-7) Camshaft assembly removed (Para. 5-9) Parts/Materials: Solvent, Dry Cleaning (Item 7, App. E) Rag, Cleaning (Item 8, App. E) A.    REMOVAL. 1. Reach into cylinder block and disengage governor (7,  Figure  5-23)  from  governor  lever  assembly (3).  Remove governor lever assembly from lever (1) by removing pin (2). 2. Remove washer (4), bearing (5), and bush (6). B.    CLEANING.   Cleaning solvents are flammable and toxic to eye, skin, and respiratory tract.  Skin and eye protections   are   required   when   working   in contact    with    cleaning    solvents.        Avoid repeated or prolonged contact.  Work in well ventilated area only.  Keep away from heat, sparks, and open flame.  Do not smoke while using  cleaning  solvent.    Failure  to  observe this warning can result in injury or death to personnel. Clean  components  with  cleaning  solvent  and  a clean rag.  Allow to air dry. Figure 5-23.  Governor Removal WARNING