ARMY TM 9-2815-257-24 AIR FORCE TO 38G1-128-2 MARINE CORPS TM 10155A/2815-24/3 3-14 Section VI.  UNIT MAINTENANCE PROCEDURES 3-12.  RECOIL STARTER ASSEMBLY MAINTENANCE This task covers removal, cleaning, inspection, and installation. INITIAL SETUP Tools: Equipment Condition: Tool Kit, General Mechanic’s Automotive None (Item 2, App. B, Sect. III) Parts/Materials: Solvent, Dry Cleaning (Item 7, App. E) Rag, Cleaning (Item 8, App. E) A.    REMOVAL. 1. Remove  recoil  starter  assembly  (1,  Figure  3-2)   from   flywheel   housing   (2)   by   removing   four screws (3). 2. Remove   plunger   (5)   from   cylinder   block   by removing three screws (6).   B.    CLEANING.   Cleaning solvents are flammable and toxic to eye, skin,   and   respiratory   tract.      Skin   and   eye protections are required when working in contact with   cleaning   solvents.      Avoid   repeated   or prolonged contact.  Work in well ventilated area only.    Keep  away  from  heat,  sparks,  and  open flame.      Do   not   smoke   while   using   cleaning solvent.    Failure  to  observe  this  warning  can result in injury or death to personnel. Figure 3-2.  Recoil Starter Removal Clean components with cleaning solvent and a clean rag.  Allow to air dry. WARNING