Custom Search
 
  
 
ARMY TM 9-2815-259-24 AIR FORCE TO 38G1-125-2 MARINE CORPS 09249A/09246A-24 4-95 (c)    Slide adapter on nose of crankshaft and install bolts. CAUTION Do not allow oil to contact coating on outer diameter of crankshaft front oil seal.  Failure to comply could result in damage to crankshaft front oil seal and oil leakage. NOTE Position spring loaded side of crankshaft front oil seal into timing gear cover first. (d)     Apply light coat of clean engine oil to flange of crankshaft front oil seal and position crankshaft front oil seal on crankshaft flange. (e)     Place installer over adapter.  Tighten screw until driver bottoms against nose on crankshaft. (11)  Install crankshaft pulley, refer to paragraph 4.9.1. (12)  Install alternator mounting bracket and alternator, refer to paragraph 3.9.1. (13)  Install fan and fan drive belt, refer to TM 9-6115-671-14. (14)  Service lubrication system, refer to TM 9-6115-671-14. 4.10.   VEHICLE ENGINE STAND NOTE The 2000 lb (908 kg) Vehicle Engine Stand (NSN 4910-01-016-1835) is referenced in this manual.  When any other repair stand is used, consult the manufacturer's instructions for mounting the engine. _________ WARNING The vehicle engine stand should be used only by qualified service technicians familiar with this equipment.  Failure to comply could result in personal injury and/or equipment damage. _________ WARNING Use alloy steel SAE Grade 8 or higher socket head cap screws when installing engine adapters on vehicle engine stand.  Use Thread Lock and Sealer (Loctite 242) or equivalent on cap screws when installing lift straps on the engine.  Tighten cap screws to 125 lb-ft (170 Nm).  Failure to comply could result in personal and/or equipment damage.


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business