ARMY TM 9-2815-259-24 AIR FORCE TO 38G1-125-2 MARINE CORPS 09249A/09246A-24 5-83 (18)   Insure that all gasket surfaces are clean and free of foreign material. (19)   Install camshaft followers, refer to paragraph 5.4.1. (20)   Install cylinder head, refer to paragraph 4.7.4. (21)   Service coolant and lubrication system, refer to TM 9-6115-671-14. 5.4.6.   CYLINDER LINERS. NOTE The following procedures require complete access to the engine.  If necessary, remove engine from generator set, refer to TM 9-6115-671-14.   Mount engine on repair stand (NSN 4910-01-016-1835 or equal) as outlined in paragraph 4.10. a.   Testing Cylinder Liner Height Prior to Removal. (1) Remove piston, refer to paragraph 5.4.5. (2) Check height of each cylinder liner using Dial Indicator.  Check height of each cylinder liner at 1, 5, 7, and 11 o’clock positions as viewed from rear of engine.  Record all measurements. (3) Compare measurements with specifications given in Table 5-9.  Replace any cylinder liner that is out of specifications, refer to step b. Table 5-9.  Cylinder Liner Height Specifications. Item Specification Cylinder Liner Height Above Block 0.001 - 0.004 in. (0.030 - 0.100 mm) Maximum permissible difference between readings within one cylinder or between adjacent cylinders 0.002 in. (0.05 mm) b.   Removal. (1) Remove piston, refer to paragraph 5.4.5. (2) Remove capscrews (1, Figure 5-70) and washers (2) securing cylinder liners (3) to cylinder block.