ARMY TM 9-2815-260-24 AIR FORCE TO 38G1-126-2 MARINE CORPS TM 09244A/09245A-24 4-87 (8) Attach Driver and thrust washer to guide plate with capscrew.  Tighten capscrew until driver bottoms on pilot. (9) Remove seal driver and pilot plate.  Check that seal and wear sleeve assembly is properly positioned on crankshaft flange and installed evenly in flywheel housing bore. (10) Install flywheel, refer to paragraph 4.8.1.d. 4.8.3.   FLYWHEEL HOUSING. NOTE The following procedures require complete access to the engine.  If necessary, remove engine from generator set, refer to TM 9-6115-672-14.   Mount engine on repair stand (NSN 4910-01-016-1835 or equal) as outlined in paragraph 4.10. a.     Removal. (1) Remove starter, refer to paragraph 4.3.2. (2) Remove flywheel, refer to paragraph 4.8.1. (3) Remove crankshaft rear oil seal and wear sleeve, refer to paragraph 4.8.2. __________ WARNING Flywheel housing is heavy.  Provide adequate lifting device to support weight.  Failure to comply could result in serious personal injury. (4) Remove bolt (4, Figure 4-58), bolt (6) and flywheel housing (1). (5) Cover all openings to prevent entry of foreign material.