ARMY TM 9-2815-260-24 AIR FORCE TO 38G1-126-2 MARINE CORPS TM 09244A/09245A-24 4-97 (10) Install crankshaft front oil seal as follows: (a) Inspect and clean seal bore in timing gear cover.  Check for nicks or burrs.  Use medium grit emery cloth to smooth rough areas. (b) Clean outer diameter of crankshaft and wear sleeve with solvent (Appendix E) or ignition cleaner and allow to dry. (c) Slide Adapter on nose of crankshaft and install bolts. CAUTION Do not allow oil to contact coating on outer diameter of crankshaft front oil seal.  Failure to comply could result in damage to crankshaft front oil seal and oil leakage. NOTE Position spring loaded side of crankshaft front oil seal into timing gear cover first. (d) Apply light coat of clean engine oil to flange of crankshaft front oil seal and position crankshaft front oil seal on crankshaft flange. (e) Place installer over adapter.  Tighten screw until driver bottoms against nose on crankshaft. (11) Install crankshaft pulley, refer to paragraph 4.9.2. (12) Install torsional damper, refer to paragraph 4.9.1. (13) Install alternator mounting bracket and alternator, refer to paragraph 3.9.1. (14) Install fan and fan drive belt, refer to TM 9-6115-672-14. (15) Service lubrication system, refer to TM 9-6115-672-14.