ARMY TM 9-2815-260-24 AIR FORCE TO 38G1-126-2 MARINE CORPS TM 09244A/09245A-24 5-17 (47) Remove retainer cushions (100, Figure 5-1), weight retainer (101), and weight retainer cushions (102). (48) If necessary, remove screws (103) and nameplate (104). (49) Remove and discard all seals. __________ WARNING Cleaning solvent is flammable and toxic to eyes, skin, and respiratory tract.   Skin and eye protection are required.  Avoid repeated/prolonged contact.   Good general ventilation is normally adequate. __________ WARNING Compressed air used for cleaning can create airborne particles that can enter the eyes.  Pressure must not exceed 30 psig (207 kPa).  Eye protection required. (50) Thoroughly clean all parts in solvent.  Dry all parts with compressed air.  Dip all parts in clean calibrating fluid. c.   Repair. (1) Disassemble fuel injection pump, refer to paragraph 5.3.1.a. (2) Inspect each component for excessive wear, scoring, corrosion, distortion, cracks, or breakage.   Replace all damaged or excessively worn parts. (3) Inspect fuel injection housing (Figure 5-16) as follows: FIGURE 5-16.  FUEL INJECTION HOUSING.