ARMY TM 9-2815-260-24 AIR FORCE TO 38G1-126-2 MARINE CORPS TM 09244A/09245A-24 5-112 6 Install valve seat inserts in cylinder head using pilot driver and valve seat insert installing adapter.  Use one end of valve seat insert installing adapter to install intake valve seat inserts, the other end is used to install exhaust valve seat inserts. 7 Grind valve seats as required to maintain correct valve recess and valve face-to- seat seal, refer to step 4 (l). FIGURE 5-94.  MEASURE VALVE SEAT BORE IN CYLINDER HEAD c.     Assembly. (1) Lubricate stems of valves (10 and 11, Figure 4-46) and valve guides with clean engine oil. NOTE If valves are reused, install valves in same location from which removed. (2) Insert valves (10 and 11) in cylinder head. (3) Use valve stem seal installer to slide valve stem seals (13) over stems of valves (10 and 11) and onto valve guide tower (3, Figure 5-95). (4) Position valve springs (4, Figure 4-46) and rotators (3) on cylinder head. (5) Compress valve springs (4, Figure 4-46) using valve spring compressor (JDE138) and install retainers on stems of valves (10 and 11). (6) Strike end of each valve three or four times using soft, non-metallic mallet to insure proper positioning of retainer locks. (7) Recheck valve recess, refer to paragraph 4.7.4.(b). (8) Test cylinder head prior to installation, refer to paragraph 4.7.4.c. (9) Install cylinder head, refer to paragraph 4.7.4.d.