Figure H-6. Cable Assembly W1 and W2 (Sheet 2 of 2).

Custom Search

Back
Figure H-6. Cable Assembly W1 and W2 (Sheet 1 of 2).

Up
TM-9-6115-666-13-P AN/MJQ-1612 60kW 50/60 Hz Power Plant Diesel Engine Driven 5 Ton Trailer Mounted Manual

Next
Figure H-7. Cable, Assembly 100 AMP/PHASE 13230E4565 AND 13230E4589 (She t 1 of 2).

ARMY TM 9-6115-666-13&P

AIR FORCE TO 35C2-3-505-1

NOTES:

1. INSULATION COLORS, IN ACCORDANCE WITH WIRE LIST, SHALL BE INCLUDED AS PART OF THE

ORDERING DATA.

2. TERMINALS SHALL BE INSTALLED IN ACCORDANCE WITH MIL-STD-454, REQUIREMENTS 19.

3. EACH INSULATED CONDUCTOR END SHALL BE STRIPPED AS NOTED WITH THEIR INDIVIDUAL

STRANDS TWISTED TOGETHER, SOLDER COATED FOR A LENGTH OF .12 FROM END USING

SOLDER, FIND NO. 6.

4. REMOVE BRAID FROM GROUND WIRES (4 AWG), TWIST TOGETHER AND INSTALL TERMINAL LUG,

FIND NO. 5 AS SHOWN.

5. AT PIGTAIL END OF CABLE THE FOUR 4 AWG GROUNDING CONDUCTORS SHALL BE TWISTED

TOGETHER, STARTING AT THE JACKET, CONDUCTORS SHELL BE SOLDER COATED FOR A

LENGTH OF .25 FROM END, USING SOLDER, FIND NO. 6.

6. HOT STAMP "97403-13230E4564-( )" WITH APPROPRIATE DASH NO. AND "W( ) IN TWO PLACES

(180 APART) ON INSULATION SLEEVING, FIND NO. 2, IN ACCORDANCE WITH MIL-E-60903.

LOCATE APPROXIMATELY AT MIDPOINT ON -1 AND BOTH ENDS OF CABLE SHIELD ON -2.

7. HOT STAMP TERMINAL DESIGNATION AS SHOWN IN WIRE TABLE IN TWO PLACES (180 APART)

ON INSULATION SLEEVING, FIND NO. 1 AND 4, IN ACCORDANCE WITH MIL-M-60903.

Figure H-6. Cable Assembly W1 and W2 (Sheet 2 of 2).

H-18