TM  5-2815-241-34&P FLYWHEEL  HOUSING  INSTALLATION INITIAL   SETUP Tools Barring  tool,  crankshaft Extension,   6-inch,   1/2-inch   drive Hammer,  plastic-faced Handle,   ratchet,   1/2-inch   drive Indicator,  dial Pliers,  slip-joint,  &inch Scribe,  machinist Socket,  3/4-inch,  1/2-inch  drive Socket,  13/16-inch,  1/2-inch  drive Socket,  7/8-inch,  1/2-inch  drive Socket,  15/16-inch,  1/2-inch  drive Wrench,   box-end,   3/4-inch Wrench,  torque,  0  to  250  ft  lb (0  to  350  N•m),  1/2-inch  drive Materials/Parts Gasket,  flywheel  housing Lockwasher,  flywheel  housing  to  engine  (nine required) Lockwasher,  flywheel  housing  to  oil  pan  (six required) Wire, locking (item 21, appendix B) Personnel  Required Two Equipment   Condition Oil  pan  installed  (page  2-96). ACTION LOCATION ITEM REMARKS 1. Cylinder block (1) New  flywheel  housing gasket  (2) Put  in. WARNING Due to excessive weight, assistance will be needed to prevent personal injury when lifting  heavy  parts. 2. Flywheel   housing   (3) Using  assistance,  aline  with  dowel  pins  and put  on. 3. Flywheel housing (3) Nine  screws  (4) and  nine  new lockwashers   (5) Using  1/2-inch  drive  15/16-inch  socket, b-inch  extension,  and  ratchet  handle, screw  in  until  snug. Do  not  tighten. 4. Cylinder block (1) Flywheel   housing   (3) Using  machinist  scribe,  mark  flywheel housing  at  12,  3,  6,  and  9  o’clock positions. 2-98