TM 5-2815-241-34&P
CAM FOLLOWER ASSEMBLY - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
22.
Two new
cup plugs (11)
23.
Two dummy screws
(10) and two lock-
screws (12)
Using arbor press and ST-1053 plug driving
mandrel, press in until flush with end of cam
follower housing (7) or 0.010 inch (0.25
mm) below edge of hole.
a. Using 1/4-inch flat-tip screwdriver,
remove two dummy screws.
b. Using 1/4-inch flat-tip screwdriver,
install and tighten two lock screws.
NOTE
FOLLOW-ON MAINTENANCE:
Install cam follower housing (page 2-70).
TASK ENDS HERE
2-263
|
|
