TM  5-2815-241-34&P FUEL PUMP CALIBRATION - CONTINUED ACTION LOCATION ITEM REMARKS THROTTLE  LEVER  TRAVEL  CHECKING  AND  ADJUSTING NOTE Do not adjust front throttle screw from valve set under throttle leakage. The front throttle screw has already been set to provide the proper deceleration time for the engine. Any changes  at  this  point  will  require  recalibration  of  throttle  leakage. Travel template no. 3375355 or protractor will be used to set fuel pump throttle lever travel adjustment. Make sure the combination of the first and third or second and fourth holes on the template are used. Any other combination will result in an inaccurate read- ing.  Correct  travel  is  27  to  29  degrees. The throttle lever may be repositioned on throttle shaft as required, to line up throttle lever   and   template   holes. 30.  Fuel  pump  (2) Throttle  lever  (5) Check  and  adjust  throttle  travel  as  follows: a. Place  travel  template  no.  3375355  (7) against  fuel  pump  housing  as  shown. b. Move throttle lever to idle position. c. Line  up  travel  template  no.  3375355  (7) idle hole with center of throttle lever. Use  straightedge  to  aline. d. Move throttle lever to full throttle position. e. Aline  travel  template  no.  3375355  (7) MAX holes with hole in throttle lever. f. If throttle lever travel is incorrect, using 7/16-inch  box-end  wrench  and  1/8- inch  flat-tip  screwdriver,  adjust  rear throttle  stop  screw  (8)  to  obtain  27-  to 29-degrees   travel. T A    2 4 2 5 6 7 2-345