TM 9-2520-272-34&P 44. REMOVE   TRANSMISSION   FROM   CONTAINER (SHEET 2 OF 2) 1 Push in and hold air release button (1) until air flow stops. 2 Using  3/4  inch  socket  and  3/4  inch  combination wrench,  remove  22  nuts  (2)  and  bolts  (3)  holding container top (4) and bottom (5) together. 3 Using  hoist  and  sling,  attach  sling  hooks  to  two brackets located diagonally opposite each other on container top (4). 4 Remove  container  top  (4)  from  container  bottom (5). 5 Remove sling hooks from container top (4). 6 Using  3/4  inch  socket,  remove  four  bolts  (6)  and washers  (7)  holding  two  caps  (8)  to  pillow  blocks (9). 7 Remove two caps (8) from pillow blocks (9). 8 Using  3/4  inch  socket,  remove  two  bolts  (10)  and washers (11) from mounting brackets (12). 9 Using  hoist  and  sling,  attach  sling  hooks  to  two lifting brackets (13) located on top of transmission. NOTE Mounting  brackets  (12)  will  come  out  of container attached to transmission. 10 Remove transmission from container bottom (5). 11 Using 9/16 inch socket and 9/16 inch combination wrench,  remove  six  bolts  (14),  washers  (15),  and nuts (16) from mounting brackets (12). 12 Remove mounting brackets (12) from transmission.  Remove the sling hooks. NOTE On early model transmissions, the installation    instructions    tag    states    to remove   and   discard   six   nuts   and   six support  brackets  that  secure  the  torque convertor to the transmission for shipment.  This tag is in 4-4  Change 2 Para.  4-4, Task 1