(6)
(7)
(8)
(9)
TM9-2815-202-34
Remove tee (53) from left cylinder head.
Remove two bolts (59), two Iockwashers (60), and two flat washers (61) securing two wiring
harness leads (62 and 63) to air inlet housing. Remove leads and discard Iockwashers.
Remove two bolts (64) and two Iockwashers (65) securing solenoid valve and bracket
assembly (66) to support (67).
Remove two screw assemblies (68) and four flat washers (69) securing solenoid valve and
bracket assembly (66) to governor housing. Remove assembly.
b. Disassembly
(1)
(2)
(3)
Disconnect wiring harness connector (70) from solenoid valve (52).
Remove four screws (71), four nuts (72), and four Iockwashers (73) securing wiring harness
connector (74) to bracket (20). Remove wiring harness (75). Discard Iockwashers.
Remove two screws (76) and two Iockwashers (77) securing solenoid valve (52) to bracket
(20). Remove solenoid valve. Discard Iockwashers.
NOTE
Model 7083-7396 uses a connector instead of an elbow for item (49) on the solenoid
valve inlet.
(4) Remove elbows (49 and 51) from solenoid valve (52).
4-31
|
|
