ARMY TM 9-2815-255-24
AIR FORCE TO 38G1-95-2
MARINE CORPS TM 2815-24/4
FIGURE 3-75. Installing Governor Arm
CAUTION
Threads on governor shaft (73) can break off If bent or dropped.
ai.
Install new seals (72, FIGURE 3-45) coated with general purpose grease (630AA) on each end of pivot shaft and
install nuts (71). Tighten nuts successively 10 to 15 in-lbs (1.1 to 1.7 Nm).
aj.
Install six weights (18, FIGURE 3-52) into weight retainer (31), refer to FIGURE 3-76.
NOTE
The two deep grooves of sleeve (19, FIGURE 3-52) should face upward. Sight across tops of
assembled weights. They should be level and collapsed against thrust sleeve.
FIGURE 3-76. Installing Weights
ak.
Insert governor thrust washer (20, FIGURE 3-52) and sleeve (19) into lower slots of weights (18) by tilting
weights outward slightly, refer to FIGURE 3-77.
3-106
|
|
