| Tweet |
Custom Search
|
|
|
||
 3500 ENGINE
SPECIFICATIONS
VALVE COVERS
(1)
Torque for bolts that hold valve cover in
position ......................... 20 + 3 Nm (15 + 2 lb. ft)
(2)
Cut seal to fit at assembly
VALVE ROCKER ARMS, LIFTERS,
AND BRIDGES
(1)
Torque for valve adjustment screw
locknut .................... 70 + 15 Nm (50 + 11 lb. ft.)
(2)
Clearance for valves:
Intake valves .......................... 0.38 mm (.015 in.)
Exhaust valves ....................... 0.76 mm (.030 in.)
(3)
Torque for bridge adjustment screw
locknut ........................ 30 + 4 Nm (22 + 3 lb. ft.)
(4)
Diameter of dowel
(new)....... 11.008 + 0.003 mm (.4334 + .0001 in.)
Bore In bridge for dowel
(new)............... 12.00 + 0.25 mm (.472 + .010 in.)
Bore in head for
dowel ...... 10.968 + 0.020 mm (.4318 + .0008 in.)
(5)
Diameter of rocker arm
shaft...... 37.084 + 0.013 mm (1.4600 + .0005 in.)
Bore In bearings for rocker arm shaft
.............. 37.140 + 0.015 mm (1.4622 + .0006 in.)
(6)
Height to top of
dowel .................... 66.5 + 0.5 mm (2.62 + .02 in.)
(7)
Guide springs must not be used again. Always
install new guide springs.
(8)
Diameter of valve lifter
(new)..... 29.937 + 0.010 mm (1.1786 + .0004 in.)
Bore In head for valve
lifter....... 30.000 + 0.025 mm (1 1811 + .0010 in.)
NOTE: FOR TORQUE VALUES NOT GIVEN, SEE THE FIRST
PAGE OF SPECIFICATIONS FOR GENERAL TIGHTENING TORQUES
15
|
||
|
||
