| Tweet |
Custom Search
|
|
|
||
 3500 ENGINE
SPECIFICATIONS
CYLINDER HEADS
NOTICE
Before installation of this cylinder head on an engine
that has water cooled manifolds, the plug at location
(A) MUST be removed.
If the engine has dry
manifolds the plug at location (A) MUST NOT be
removed.
(1)
Put 5P3931 Anti-Seize Compound on the
threads of the bolts and tighten them as follows:
a. Tighten all the bolts to
30 + 5 Nm (22 + 4 lb. ft.)
b. Tighten bolts 1 through 8
in number sequence
to ................... 270 + 35 Nm (200 26 lb. ft.)
c.
Tighten bolts 1 through 8 In number sequence
to ................... 450 20 Nm (330 + 15 lb. ft.)
(2)
Depth that two plugs are installed
in top of cylinder head
.................................. 9.0 + 0.5 mm (.35 + .02 in )
Use 6V1541 Quick Cure Primer and 9S3265
Retaining Compound in the plug bores at
assembly.
(3)
Height of cylinder head
(new)........... 142.00 + 0.15 mm (5.591 + .006 in.)
(4)
Depth below bottom of chamfer that the seven
plugs are installed In cylinder
head.......................... 1.0 + 0.5 mm (.04 + .02 In.)
Use 6V1541 Quick Cure Primer and 9S3265
Retaining Compound in the plug bores at
assembly.
16
|
||
|
||
