Custom Search
 
  
 
3500 ENGINE
SPECIFICATIONS
OIL PUMP
(2W5477)
Rotation of drive gear (as seen from drive
end)
........................ Clockwise
(1)
Length of gears
84.000 0.015 mm (3.3071
(new)...............
.0006 in.)
Depth of bores for gears
....... 84.150 0.020 mm (3.3130
(new)
.0008 in.)
(2)
Diameter of gear
shafts (new) .... 31.742 0.008 mm (1.2497
.0003 in.)
Bore in bearings for gear shafts (after
assembly) ....... 31.811 0.013 mm (1.2524
.0005 in.)
(3)
Distance dowels extend
from cover ...... 6.0 0.5 mm (.24 .02 in.)
(4)
Distance from the end of the idler shafts
to gear faces.......... 34.0 0.5 mm (1.34 .02
in.)
(5)
Distance from the end of the drive shaft
to gear face .... 47.0 0.5 mm (1.85 .02 in.)
(6)
Depth that bearings are installed
in cover  ....... 1.5 0.5 mm (.06 .02 in.)
(7)
Depth that bearings are installed
in housing. ...... 1.5 0.5 mm (.06 .02 in.)
(8)
The location of each bearing junction must be as
shown.  Position bearing junctions from the centerline
through the bearing bores to an angle of .. 45 15
(9)
2S2760 Spring (oil pressure relief):
Length under test force. .....
117.9 mm (4.64
in.)
Test force ....... .490 27 N (110 6 lb.)
Free length after test .................... 52.9 mm
(6.02 in.)
Outside diameter.  ...........
27.00 mm (1.063
in.)
NOTE: FOR TORQUE VALUES NOT GIVEN, SEE THE FIRST 27 PAGE OF SPECIFICATIONS FOR
GENERAL TIGHTENING TORQUES
27


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business