| Tweet |
Custom Search
|
|
|
||
 3500 ENGINES
DISASSEMBLY AND ASSEMBLY
WATER TEMPERATURE REGULATORS
INSTALL WATER TEMPERATURE
REGULATORS
1355-12
Tools Needed
A
1P510
Driver Group
1
1.
If the ball and ferrule were removed, install the
ball and use tooling (A) to install the ferrule until
it makes contact with the bottom of the bore.
Make sure the open end of the ferrule is toward
the outside of the housing.'
2.
If the seals were removed, use tooling (A) to
install the seals in the housing. Make sure the
lip of the seal is toward the inside of the housing
as shown.
NOTICE
If the water temperature regulators are installed
wrong, it will cause the engine to overheat.
3.
Install water temperature regulators (1) in the,
housing with the spring up as shown.
4.
Put housing (2) and the gasket in position on the
regulators. Install the bolts to hold the housing in
position.
5.
Fasten a hoist to water temperature regulator
housings (3) and put the housings and gaskets
in position on the engine. Install the bolts to hold
the housings to water manifolds (5) and brackets
(4).
6.
Install the tube between the aftercooler adapter
and the regulator housings.
7.
Put the plate on top of the oil lifter housing and
install the bolts. Install the fuel lines and the
clamps on the water temperature regulator
housings.
end by:
a) install fuel filter housing
273
|
||
|
||
