| Tweet |
Custom Search
|
|
|
||
 3500 ENGINES
DISASSEMBLY AND ASSEMBLY
CRANKSHAFT FRONT SEAL AND WEAR SLEEVE
3.
Install tool (B) over the studs of tooling (A).
Install nuts (C) and tighten the nuts evenly until
the seal is against the bottom of the adapter
bore.
4.
Remove nuts (C), tool (B) and tooling (A) from
the adapter.
NOTE: Do not put engine oil on the lip of the seal during
installation. Lubrication of the seal at installation can be
a wrong indication for linkage at a later time.
5.
Put clean engine oil on the O-ring seal and,
install the seal on the adapter.
6.
Install tooling (D) on the end of the crankshaft.
7.
Install guide bolts (E) in the drive housing. Put
adapter (3) in position on guide bolts (E) and
over tooling (D). Make sure the wear sleeve
makes contact with the end of the crankshaft.
8.
Install tool (B) over the small outside diameter of
tool (F) until tool (B) is against the shoulder on
tool (F).
9.
Install tooling(B) and(F) as a unit on the guide
bolts and over the locator.
10.
Put clean engine oil on the face of nut (G) and,
install nut (G) on the locator. Tighten nut (G)
until the wear sleeve and adapter are in posi-
tion.
11.
Remove the tooling from the engine.
12.
Install bolts (4) to hold adapter (3) in position.
end by:
a) install crankshaft vibration damper
355
|
||
|
||
