| Tweet |
Custom Search
|
|
|
||
 3500 ENGINES
DISASSEMBLY AND ASSEMBLY
FRONT DRIVE HOUSING
INSTALL FRONT DRIVE HOUSING
1157-12
Tools Needed
A
B
6V2156
Link Bracket
2
1P520
Drive Group
1
1.
Put the housing gasket in position on the
front of the cylinder block. Install two 5/8"-
11 NC guide bolts (1) in the cylinder block.
2.
Fasten a hoist to front drive housing (2) with
tooling (A). Put housing (2) in position on
the guide bolts and install the bolts to hold it
in position. Remove the guide bolts and
install the remainder of the bolts. Tighten
all of the bolts evenly and cut the housing
gasket even with the
bottom of the
cylinder block.
3.
Fasten a hoist to the engine and lift the
engine enough to remove the plates
between the cylinder block and the oil pan.
If the oil pan gasket damaged, the engine
will have to be removed from the oil pan to
make a replacement of the gasket. Lower
the engine on the oil pan and remove the
guide bolts of the oil pan. Install all of the
bolts that hold the oil pan to the engine.
4.
Put clean engine oil on the O-ring seals and
install cover (3) on the drive housing.
5.
Put washer (4) in position inside the drive
housing.
360
|
||
|
||
