| Tweet |
Custom Search
|
|
|
||
 3500 ENGINES
DISASSEMBLY AND ASSEMBLY
CAMSHAFTS
INSTALL CAMSHAFTS
1210-11
Tools Needed
A
B
6V4019
Camshaft Pilot Group
1
9S9082
Engine Turning Tool
1
1.
If the 3512 Camshafts were taken apart, make
sure spacer (2) is in position between the
camshaft and camshaft assembly. Put 9S3263
Thread Lock on the threads of bolts (1) and
tighten the bolts by hand only to a torque of 45 +
7 Nm (33 + 5 lb. ft.).
NOTE:
Make sure the camshafts are installed
respective to the marks (Rear L.H., Rear R.H.) on the
ends of the camshafts.
2.
Install the pilot assembly part of tool group (A) to
one end of the camshaft and the handle part of
tool group (A) to the other end.
3.
Fasten a hoist to camshaft (3) and put the
camshaft in position and push it into the engine
block. Remove the hoist and tool group (A).
4.
Install washers (4) on each side of the engine to
hold the camshafts in position.
5.
Remove timing pins(5) from their storage
positions on each side of the engine.
403
|
||
|
||
