| Tweet |
Custom Search
|
|
|
||
 3500 ENGINES
DISASSEMBLY AND ASSEMBLY
CAMSHAFTS
6.
Turn the camshafts until timing pins (5) can be
installed through the engine block and into the
grooves (slots) in the camshafts.
7.
Remove cover (6) and plug (7) from the right
front side of the flywheel housing.
8.
Put timing bolt (8) in position in the flywheel
housing. Use tool (B) and a ratchet wrench to
turn the flywheel until the timing pin engages with
the hole in the flywheel. The No. 1 cylinder is
now at top center.
9.
Put drive gears (9) in position on the end of the
camshaft on each side.
10.
Install plate (11) and the bolts to hold the drive
gear to the camshaft. Tighten the bolts evenly to
a torque of 100 + 15 Nm (75 + 10 lb. ft.). Hit
the plate with a hammer and tighten the bolts
again to the same torque. Do this until the
torque does not change.
11.
Install the gasket and cover (10) over the
camshaft.
404
|
||
|
||
