TM    5-2815-241-34&P FUEL  INJECTOR  INSTALLATION INITIAL  SETUP Tools Materials/Parts Extension,   6-inch,   1/2-inch   drive Handle,   ratchet,   1/2-inch   drive Puller,  fuel  injector Socket,  1/2-inch,  1/2-inch  drive Wrench,  torque,  0  to  250  ft  lb (0  to  350  N•m),  1/2-inch  drive Oil, lubricating (item 12, appendix B) Packing,  preformed  (fuel  injector) Gasket  (two  required) Equipment   Condition Injector  timing  adjusted  (page  2-74). ACTION LOCATION ITEM REMARKS 1. Fuel injector (1) NOTE Steps given are typical for all six fuel injectors. Coat packings and injector with lubricating oil. Two  new  gaskets  (2) and   preformed packing  (3) Roll  on. NOTE Install fuel injectors in same cylinder from which they were removed. Position  fuel  injectors  with  filter  screen  facing  exhaust  manifold  side  of  engine. 2.  Cylinder  head  (4) Fuel  injector  (1) Aline and put in. NOTE Method for mounting valve spring compressor is at discretion of using facility. 2-78