TM   5-2815-241-34&P WATER  INLET  HOUSING  INSTALLATION INITIAL   SETUP Tools Materials/Parts Extension,   6-inch,   1/2-inch   drive Handle,   ratchet,   1/2-inch   drive Socket,   9/16-inch,   1/2-inch   drive Gasket,  water  inlet  housing Lockwasher   (five   required) Wrench,  torque,  0  to  150  ft  lb  (0  to 210  N•m),  1/2-inch  drive Equipment   Condition Water  pump  installed  (page  2-121). ACTION LOCATION ITEM REMARKS Right front of cylinder   block   (1) New  water  inlet housing  gasket  (2), water  inlet  housing (3),  five  new  lock- washers  (4),  and five  screws  (5) a. Position  water  inlet  housing  and  gasket on  cylinder  block. b. Using   1/2-inch   drive   9/16-inch   socket, 6-inch  extension,  and  ratchet  handle, screw  in  five  screws  and  lockwashers until  snug. c. Using   1/2-inch   drive   9/16-inch   socket, 6-inch  extension,  and  0  to  150  ft  lb  (0  to 210  N•m)  torque  wrench,  torque  to  30  to 35 ft lb (40.6 to 47.4 N•m). TASK ENDS HERE T A    2 4 2 4 1 6 2-124